730406 - proper power cables for new PHX1 Seamicro

Status: RESOLVED FIXED

(Infrastructure & Operations :: DCOps, task)

Description

[Jake Maul [:jakem]]

+++ This bug was initially created as a clone of Bug #730393 +++

The Seamicro unit is racked in cab 7, which is a 60A 208V cab, using these PDUs: http://www.servertech.com/products/smart-pdus/smart-cs-12hd-hy-50-60a-3ph-12xc19-with-pips

We need to get 4 power cables that will mate up to this outlet. Seamicro says the plug on their side is "LS26"... I don't know if that's the male or female end, though. I can't find *any* information about this outlet anywhere online.

The outlets on the PDU are C19's.

The cables Seamicro ships with the unit are obviously good enough on their end, but the other end is a C13. A simple short C14-C19 would make an acceptable adapter.


SO:

We need 4x C14 to C19 power cables... 3ft length is sufficient. This would function as an adapter attached to the end of their cables.

Alternatively, we need 4x LS26 to C19 power cables, ~10-15ft length? This would replace their cables outright. Seamicro is investigating whether or not they can provide this to us.

Comment 1

[Derek Moore [:dmoore]]

Appropriate cords ordered for Phoenix:

http://www.stayonline.com/iec-c20-c13-power-cords.aspx

ETA Monday, 3/2

Comment 2

[Derek Moore [:dmoore]]

Power cords installed.